Cummins ISB6.7 CM2350 (2013-17) Fault Code: 1695 PID: SID 232 SPN: 3513 FMI: 3 Sensor Supply 5- Voltage Above Normal or Shorted to High Source

Cummins ISB6.7 CM2350 (2013-17) Fault Code: 1695 PID: SID 232 SPN: 3513 FMI: 3 Sensor Supply 5- Voltage Above Normal or Shorted to High Source

Circuit Description
The sensor supply 5 circuit of the engine control module (ECM) provides a 5 volt supply for the aftertreatment diesel particulate filter differential pressure sensor, remote accelerator, engine coolant level sensor, fan speed sensor, and the accelerator position sensor 2.

Component Location
Sensor Supply 5 is dedicated for the secondary accelerator pedal position sensor in the OEM wiring harness. Sensor supply 5 can also be used for other sensors in the OEM wiring harness.

Conditions for Running the Diagnostics
This diagnostic runs continuously when the keyswitch is in the ON position or when the engine is running.

Conditions for Setting the Fault Codes
The Engine Control Module (ECM) detected the sensor supply 5 signal voltage was greater than 5.25-VDC for more than 1 second.

Action Taken When the Fault Code is Active
1)The ECM illuminates the amber CHECK ENGINE lamp and/or the Malfunction Indicator Lamp (MIL) immediately when the diagnostic runs and fails.
2)The engine will have limp-home throttle control only.

Conditions for Clearing the Fault Code
1)To validate the repair, perform a key cycle, start the engine and let it idle for 1 minute.
2)The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
3)The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
4)For On-Board Diagnostics (OBD) engines, the ECM will extinguish the Malfunction Indicator Lamp (MIL) after three consecutive trips where the diagnostic runs and passes.
5)The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.

Shop Talk
High voltage on the 5-VDC supply wire can be caused by a short circuit to a power supply, a damaged sensor, or a damaged ECM power supply.

Reference the appropriate OEM wiring diagram when troubleshooting circuits that utilize wiring supplied by the OEM.

For intermittent power supply and datalink communication issues with Aftertreatment Components, it is highly recommended that the OEM Power Distribution Center fuses and relays be thoroughly checked for loose, missing or intermittent connections.

Possible Causes:
1) OEM harness failure
2) ECM calibration