Detroit DD13 EPA07 (2007-09) Fault Code: SPN 157 FMI 16 (MCM) Fuel Rail Pressure Too Low

DESCRIPTION:
Fuel rail pressure too low.

MONITORED PARAMETER:
Injector cylinder #1 needle control valve.

TYPICAL ENABLING CONDITIONS:
Fuel rail pressure desired – fuel rail pressure actual > 200 bar.

MONITOR SEQUENCE:
None

EXECUTION FREQUENCY:
Continuous when enabling conditions met.

TYPICAL DURATION:
Eight seconds

DASH LAMPS:
1. MIL
2. CEL

ENGINE REACTION:
Derate 25%

VERIFICATION:
Engine Idle: One minute.

NOTE: The motor control module (MCM) monitors the rail pressure and when rail pressure deviation is greater than 200 bar for eight seconds, the MCM sets the code.

POSSIBLE CAUSES:
1. External fuel leakage between the high pressure pump and fuel injectors.
2. Pressure limiting valve leakage (Internal).
3. Fuel filter integrity (Loose caps, plugged filters).
4. Fuel supply issues (fuel level, fuel aeration, leaking fuel lines, fuel restrictions).
5. Intermittent loss of engine speed signal.
6. High pressure pump internal failure.
7. Fuel injector (amplifier or needle) leakage.
8. Fuel contamination.
9. Rail pressure sensor.
10. Motor control module (MCM).

NOTE: The ECM monitors the rail pressure and when it changes more than 200 bar for 8 seconds the code is set.

PROBABLE CAUSES:
1. External fuel leakage between the high pressure pump and fuel injectors.
2. Pressure limiting valve leakage (internal).
3. Fuel filter integrity (loose caps, plugged filters).
4. Fuel supply issue (fuel level, fuel aeration, leaking fuel lines, fuel restrictions).
5. Intermittent loss of engine speed signal.
6. High pressure pump internal failure.
7. Fuel injector leakage.
8. Fuel contaminated (oil, gas, etc…).
9. Rail pressure sensor or connector/harness.
10. Engine ECM failure.